It is essential that, prior to performing any task on this equipment, this individual shall have read and understood this document and any referenced materials. It is expected that this individual possesses independent training that will enable them to perform their assigned tasks properly and safely.
This document is intended for use by owner-authorized operating/service personnel. Failure to comply with any of these requirements could result in serious damage to the equipment and the property in which it is situated, as well as severe personal injury or death to themselves and people at the site. It is the obligation and responsibility of operating/service personnel to identify and recognize these inherent hazards, protect themselves, and proceed safely in completing their tasks. Each of these items has the potential, if mis-used or handled improperly, to cause bodily injury or death. During installation, operation, maintenance or service, individuals may be exposed to certain components or conditions including, but not limited to: refrigerants, oils, materials under pressure, rotating components, and both high and low voltage. This equipment is a relatively complicated apparatus.
READ BEFORE PROCEEDING! GENERAL SAFETY GUIDELINES 1" DEFLECTION – WEIGHT DISTRIBUTION POINT SPRING LOCATION.SEISMIC WEIGHT DISTRIBUTION POINT SPRING LOCATION.TABLE 54 – ISN OPERATIONAL AND FAULT CODES.10 – PRINTER TO MICROBOARD ELECTRICAL CONNECTIONS TABLE 49 – KEYPAD PIN ASSIGNMENT MATRIX.9 – MICROBOARD RELAY CONTACT ARCHITECTURE TABLE 43 – COMPRESSOR OPERATION – LOAD LIMITING.TABLE 42 – LOW AMBIENT CONDENSER FAN CONTROL – DISCHARGE PRESSURE CONTROL.TABLE 41 – LOW AMBIENT CONDENSER FAN CONTROL – AMBIENT TEMPERATURE AND DISCHARGE PRESSURE CONTROL.TABLE 40 – CONDENSER FAN CONTROL USING DISCHARGE PRESSURE ONLY.TABLE 39 – CONDENSER FAN CONTROL USING OUTDOOR AMBIENT TEMPERATURE AND DISCHARGE PRESSURE.TABLE 38 – RETURN CHILLED LIQUID CONTROL FOR 4 COMPRESSORS (6 STEPS).TABLE 37 – RETURN CHILLED LIQUID CONTROL FOR 6 COMPRESSORS (8 STEPS).TABLE 35 – LEAVING CHILLED LIQUID CONTROL FOR 2 COMPRESSORS (SINGLE SYSTEM).TABLE 34 – LEAVING CHILLED LIQUID CONTROL FOR 3 COMPRESSORS (SINGLE SYSTEM).TABLE 33 – LEAVING CHILLED LIQUID CONTROL FOR 4 COMPRESSORS (6 STEPS).TABLE 32 – LEAVING CHILLED LIQUID CONTROL FOR 6 COMPRESSORS (8 STEPS).TABLE 31 – UNIT KEYS PROGRAMMING QUICK REFERENCE LIST.TABLE 30 – SETPOINTS QUICK REFERENCE LIST.TABLE 29 – PROGRAM KEY LIMITS AND DEFAULTS.TABLE 28 – COOLING SETPOINTS PROGRAMMABLE LIMITS AND DEFAULTS.TABLE 24 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 23 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 22 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 21 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 20 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 19 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 18 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 17 – WEIGHT DISTRIBUTION/CENTER OF GRAVITY.TABLE 14 – ETHYLENE GLYCOL CORRECTION FACTORS.TABLE 10 – ETHYLENE GLYCOL CORRECTION FACTORS.3 – OPTIONAL SINGLE POINT POWER SUPPLY WIRING OPTIONAL SINGLE POINT POWER SUPPLY WIRING – (0040 - 0080).STANDARD POWER SUPPLY WIRING – (0014 - 0080).
0 kommentar(er)
